conntrack-sync: adjust CLI to latest version

This commit is contained in:
Christian Poessinger 2021-07-02 22:08:00 +02:00
parent e74aca7d00
commit 949a0a703a

View File

@ -42,9 +42,7 @@ Configuration
Accept only certain protocols: You may want to replicate the state of flows
depending on their layer 4 protocol.
Protocols are: tcp, sctp, udp and icmp.
.. note:: When using multiple protocols they must be separated by comma.
Protocols are: tcp, sctp, dccp, udp, icmp and ipv6-icmp.
.. cfgcmd:: set service conntrack-sync event-listen-queue-size <size>
@ -64,7 +62,7 @@ Configuration
Only VRRP is supported. Required option.
.. cfgcmd:: set service conntrack-sync ignore-address ipv4 <x.x.x.x>
.. cfgcmd:: set service conntrack-sync ignore-address <x.x.x.x>
IP addresses or networks for which local conntrack entries will not be synced
@ -110,7 +108,9 @@ Operation
1015734272 172.31.20.12:60286 239.10.10.14:694 udp [17] 29
1006239392 10.35.101.221 172.31.120.21 icmp [1] 29
.. note:: If the table is empty and you have a warning message, it means
.. note::
If the table is empty and you have a warning message, it means
conntrack is not enabled. To enable conntrack, just create a NAT or a firewall
rule. :cfgcmd:`set firewall state-policy established action accept`
@ -184,7 +184,9 @@ Now configure conntrack-sync service on ``router1`` **and** ``router2``
set high-availablilty vrrp group internal virtual-address ... etc ...
set high-availability vrrp sync-group syncgrp member 'internal'
set service conntrack-sync accept-protocol 'tcp,udp,icmp'
set service conntrack-sync accept-protocol 'tcp'
set service conntrack-sync accept-protocol 'udp'
set service conntrack-sync accept-protocol 'icmp'
set service conntrack-sync failover-mechanism vrrp sync-group 'syncgrp'
set service conntrack-sync interface 'eth0'
set service conntrack-sync mcast-group '225.0.0.50'