automation: add custom pre/post-commit hooks (#550)

docs/automation/command-scripting.rst

@@ -105,6 +105,45 @@ group, the script can be safeguarded like this:
       exec sg vyattacfg -c "/bin/vbash $(readlink -f $0) $@"
   fi
 
+Executing pre-hooks/post-hooks Scripts
+--------------------------------------
+
+Vyos has the ability to run custom  scripts before and after each commit
+
+The default directories where your custom Scripts should be located are:
+
+.. code-block:: none
+
+  /config/scripts/commit/pre-hooks.d   - Directory with scripts that run before 
+                                         each commit.
+
+  /config/scripts/commit/post-hooks.d  - Directory with scripts that run after
+                                         each commit.
+
+Scripts are run in alphabetical order. Their names must consist entirely of 
+ASCII upper- and lower-case letters,ASCII digits, ASCII underscores, and 
+ASCII minus-hyphens.No other characters are allowed.
+
+.. note:: Custom scripts are not executed with root privileges (Use sudo inside if this is necessary).
+
+A simple example is shown below, where the ops command executed in 
+the post-hook script is "show interfaces".
+
+.. code-block:: none
+
+  vyos@vyos# set interfaces ethernet eth1  address 192.0.2.3/24
+  vyos@vyos# commit
+  Codes: S - State, L - Link, u - Up, D - Down, A - Admin Down
+  Interface        IP Address                        S/L  Description
+  ---------        ----------                        ---  -----------
+  eth0             198.51.100.10/24                  u/u
+  eth1             192.0.2.3/24                      u/u
+  eth2             -                                 u/u
+  eth3             -                                 u/u
+  lo               203.0.113.5/24                    u/u
+                  
+
+
 Postconfig on boot
 ------------------