diff --git a/docs/configuration/service/pppoe-server.rst b/docs/configuration/service/pppoe-server.rst
index ad99cec0..69e357f3 100644
--- a/docs/configuration/service/pppoe-server.rst
+++ b/docs/configuration/service/pppoe-server.rst
@@ -1,3 +1,5 @@
+:lastproofread: 2022-09-17
+
 .. _pppoe-server:
 
 ############
@@ -106,10 +108,10 @@ and then configure it.
 
 .. cfgcmd:: set service pppoe-server authentication radius server <address>
    key <secret>
-  
+
    Use this command to configure the IP address and the shared secret
    key of your RADIUS server.  You can have multiple RADIUS servers
-   configured if you wish to achieve redundancy. 
+   configured if you wish to achieve redundancy.
 
 
 .. code-block:: none
@@ -169,25 +171,24 @@ CoA request.
 Automatic VLAN Creation
 -----------------------
 
-.. cfgcmd:: set service pppoe-server interface <interface>
-   <vlan-id | vlan range> <text>
+.. cfgcmd:: set service pppoe-server interface <interface> vlan <id | range>
 
-   VLAN's can be created by accel-ppp on the fly via the use of a Kernel
-   module named `vlan_mon`, which is monitoring incoming vlans and
-   creates the necessary VLAN if required and allowed. VyOS supports the
-   use of either VLAN ID's or entire ranges, both values can be defined
-   at the same time for an interface. When configured, the PPPoE will
-   create the necessary VLANs when required. Once the user session has
-   been cancelled and the VLAN is not needed anymore, VyOS will remove
-   it again.
+   VLAN's can be created by Accel-ppp on the fly via the use of a Kernel module
+   named `vlan_mon`, which is monitoring incoming vlans and creates the
+   necessary VLAN if required and allowed. VyOS supports the use of either
+   VLAN ID's or entire ranges, both values can be defined at the same time for
+   an interface.
+
+   When configured, PPPoE will create the necessary VLANs when required. Once
+   the user session has been cancelled and the VLAN is not needed anymore, VyOS
+   will remove it again.
 
 .. code-block:: none
 
-  set service pppoe-server interface eth3 vlan-id 100
-  set service pppoe-server interface eth3 vlan-id 200
-  set service pppoe-server interface eth3 vlan-range 500-1000
-  set service pppoe-server interface eth3 vlan-range 2000-3000
-
+  set service pppoe-server interface eth3 vlan 100
+  set service pppoe-server interface eth3 vlan 200
+  set service pppoe-server interface eth3 vlan 500-1000
+  set service pppoe-server interface eth3 vlan 2000-3000
 
 
 Bandwidth Shaping
@@ -201,7 +202,7 @@ For Local Users
 
 .. cfgcmd:: set service pppoe-server authentication local-users username <name>
    rate-limit <download | upload>
-  
+
    Use this command to configure a data-rate limit to PPPOoE clients for
    traffic download or upload. The rate-limit is set in kbit/sec.